Set security policies from-zone internal to-zone internet policy allow-internal-clients match application any Set security policies from-zone internal to-zone internet policy allow-internal-clients match destination-address any Set security policies from-zone internal to-zone internet policy allow-internal-clients match source-address network_239 Set security zones security-zone internal address-book address network_11 192.168.11.0/24 Set security zones security-zone internet interfaces ge-0/0/0.0 Set security zones security-zone internal interfaces ge-0/0/1.0 host-inbound-traffic system-services ssh Set security zones security-zone internal interfaces ge-0/0/1.0 host-inbound-traffic system-services ping Set interfaces ge-0/0/1 description To_WiFi_router Set interfaces ge-0/0/0 description Cable_Modem_Internet_Link Set system services ssh protocol-version v2 When ethernet-switching family is configured on an interface, no other family type can be configured on the same interface. Interface ge-0/0/0.0 must be configured under interfaces I have a CCNP but security is all new to me plus I'm rusty to Juniper. I'm getting this error when committing and I don't understand. Outside internet => Cable Modem => Juniper SRX210 => Trendnet TEW-810DR wifi (cheap 802.11ac WiFi router, there are computer hooked up through WiFi but no Ethernet right now) I thought you might be interested to know.Hello I am trying to connect my SRX210 to my home personal network. Newer IOS versions also display this information in show eigrp protocols: Router# show eigrp protocols The EIGRP RID can be always seen in the heading of the show ip eigrp topology: Router# show ip eigrp topologyĮIGRP-IPv4 Topology Table for AS(1)/ ID(10.255.255.1)Ĭodes: P - Passive, A - Active, U - Update, Q - Query, R - Reply, Topology-ids from peer - 0 Router# show ip eigrp neighbors detail H Address Interface Hold Uptime SRTT RTO Q Seq With neighbors of a router, you can pull out the show ip eigrp neighbor detail which shows the TLV version advertised by the particular neighbor: Router# show ip eigrp neighbors detail It is unfortunately somewhat difficult to determine what TLV version does a particular router use, but if you execute show eigrp plugins and see the "eigrp-release" plugin of the version 8.0 and higher, this EIGRP supports TLV 1.2 and TLV 2.0. Both TLV 2.0, 3.0, and 4.0 attach EIGRP RIDs both to internal and external routes. Newer TLV versions are TLV 2.0 (multi-protocol TLVs used with EIGRP Wide Metrics), TLV 3.0 (multi-topology TLVs, deprecated), and TLV 4.0 (used in SAF, Service Advertisement Framework). The first TLV version was 1.2 which was used up to and including IOS 12.4T this TLV version only included the RID with external (redistributed) routes. We've seen situations when a router has been migrated to another one with the original one just being readdressed but not reloaded, and that caused two routers in the network to have the same EIGRP RID, resulting in both routers mutually ignoring their own advertised routes.ĮIGRP exchanges routing and metric information using various TLV (Type-Length-Value) versions. It is perhaps not so publicly known but they are used, and their relative obscurity gives rise to some unexpected issues - most importantly, a router will ignore any route that is marked with its own RID. In fact, EIGRP does have and use Router IDs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |